MobileRead Forums - View Single Post

kdsksg · 04-19-2017, 01:33 PM

All of the times that I have tried to connect CC and calibre, that green light has been on, with the IP address and port listed, so I don't think that that is the issue.

Would that explain why the connection only succeeds rarely, or why it worked consistently (at least for the remainder of the evening) when I restarted my router?

I opened calibre in debug mode again, started wireless device connection, attempted to connect twice (with no success), stopped wireless device connection, started it again, and let it sit for a little bit (just in case the wireless driver is slow to start, as you mentioned) before trying to connect again (still no success), before stopping wireless device connection and closing the debug version of calibre. The debug log didn't seem to contain those SMART_DEV lines that are supposed to be there.
I waited for approximately 8 minutes before attempting to connect, should I give it more time for the WD driver to start? Should I reset my router again (which should hopefully give another successful connection) and provide a debug log of that?

Then I tried uninstalling the Marvin and iOS plugins, but only the iOS one could be disabled - it said that disabling the Marvin XD plugin was not allowed. When I opened calibre, it said that Marvin XD plugin requires the iOS plugin, so they might have both been disabled...?
I started wireless device connection and gave it another ~7 minutes to start up before attempting to connect (another failure), stopping wireless device connection, and closing the debug calibre. This debug log seems to be even less complete than the previous ones, not even getting past "Starting up...."

I've emailed both of these debug logs, for completeness.

If I do upgrade my calibre version, as it seems like the next step may be, how would I go about downgrading back to this one? I'd like to make sure I know how to do that, if it comes to it.

04-19-2017, 01:33 PM	#12
kdsksg Member Posts: 13 Karma: 10 Join Date: Apr 2015 Device: iphone 6 Marvin	All of the times that I have tried to connect CC and calibre, that green light has been on, with the IP address and port listed, so I don't think that that is the issue. Would that explain why the connection only succeeds rarely, or why it worked consistently (at least for the remainder of the evening) when I restarted my router? I opened calibre in debug mode again, started wireless device connection, attempted to connect twice (with no success), stopped wireless device connection, started it again, and let it sit for a little bit (just in case the wireless driver is slow to start, as you mentioned) before trying to connect again (still no success), before stopping wireless device connection and closing the debug version of calibre. The debug log didn't seem to contain those SMART_DEV lines that are supposed to be there. I waited for approximately 8 minutes before attempting to connect, should I give it more time for the WD driver to start? Should I reset my router again (which should hopefully give another successful connection) and provide a debug log of that? Then I tried uninstalling the Marvin and iOS plugins, but only the iOS one could be disabled - it said that disabling the Marvin XD plugin was not allowed. When I opened calibre, it said that Marvin XD plugin requires the iOS plugin, so they might have both been disabled...? I started wireless device connection and gave it another ~7 minutes to start up before attempting to connect (another failure), stopping wireless device connection, and closing the debug calibre. This debug log seems to be even less complete than the previous ones, not even getting past "Starting up...." I've emailed both of these debug logs, for completeness. If I do upgrade my calibre version, as it seems like the next step may be, how would I go about downgrading back to this one? I'd like to make sure I know how to do that, if it comes to it.