View Single Post
Old 04-08-2017, 09:59 AM   #7
UncleZeno
Connoisseur
UncleZeno began at the beginning.
 
Posts: 70
Karma: 10
Join Date: May 2016
Device: Onyx N96ML
Thumbs down

Quote:
Originally Posted by cienanos View Post
Hi, I'm having an issue with the digitizer on my N96ML and I wanted to see if it had affected anyone else.

Very often when I start up my reader, I'll find that it is not responsive to the stylus, and what's more, the reader will act as if the stylus is tapping on a point in the lower left corner of the screen. This will usually trigger the "Library" app to open. It's basically making the reader unusable because I can't rely on it to read something when I want to.

I have installed firmware 1.8.1, and it seems like it started after I did this, but not immediately after, so I'm not sure if it's responsible.

Assuming this is a hardware issue, do I have any chance of getting this fixed? I bought it new in the US from a wholesale seller on eBay -- it came with the warranty documentation, but from reading other posts it seems like that might be useless.

Is there anything I can do to resolve this issue?

Update: wiping data/cache didn't do anything
Hello,

I have exact same issue after upgrading to firmware 1.8.1 but to me the problem is when I try to write on scribble. From time to time I get some lines as I started typing from the down side of the screen... attached is a picture showing the problem I experience putting down some numbers.

The numbers 80, 112 and 128 on the left side had the issue as soon as I started writing them. You can notice the lines going to the end of the screen... very annoying and not sure why this is happening just after the firmware upgrade...
Attached Thumbnails
Click image for larger version

Name:	photo_2017-04-08_15-59-02.jpg
Views:	180
Size:	79.8 KB
ID:	156066  

Last edited by UncleZeno; 04-08-2017 at 10:02 AM.
UncleZeno is offline   Reply With Quote