Quote:
Originally Posted by GeoffR
Is there any difference in how the brightness adjustment slider works in the 4.x firmware compared to the 3.x firmware, other than the buttons adjusting in 1% steps from 1% to 5% and in 5% steps above that, instead od 10% steps everywhere?
On my Glo with firmware 3.19.5761 I set the brightness level by dragging the slider until it is close to the value I want, and then rolling my finger a bit to do the fine adjustment to the exact value. Is that not possible with the 4.x firmware?
|
With the 4.x firmware, you have to play around with the slider to get the correct value if you want it past 5% as you get 5% steps which are not good. As for using the slider on the left side of the screen, that's worthless now.