Quote:
Originally Posted by nasser
Working OK on PW1, KT3! Will try later on PW3.
I tried running it in two ways: through SSH from PC and directly through kterm.
There were some differences in the memory usage. When starting, Popeye declares the amount of memory it is using and this figure obviously varies with the actual memory available.
PW1: through SSH - 128 MB used, through kterm - 64 MB used
KT3: through both SSH and kterm - 256 MB used
Not clear why the difference exists for PW1.
|
PW-1 is running firmware 5.6.1.1 or earlier and has 1/2 the ram.
(for both reasons, memory management is different)