Quote:
Originally Posted by GreatSyxsuke
I have a KT2, the serial starts with 90C6 07
The booklet version of KUAL
I followed the instructions found on this site, back when it was first released. I made no deviations from the instructions.
Up until yesterday, it worked fine everytime I needed to change anything in KUAL or MrPI. The ;log MrPI method doesn't work now, I tried it and waited for ten minutes or more.
|
That sounds like the "reset" menu selection was done to the device.
or a "DO_FACTORY_RESTORE" was placed at the top of visible USB storage.
A simple Amazon update should not have done that;
UNLESS
If it was very early (within the first few days), it could have been before the ";log MrPI" feature was added to the things being bridged.
Check your current firmware version.
Also check if the "OTA blocker" directory name is still in-place at the top level of visible USB storage.
Do you have kTerm or USBnetworking installed?