MobileRead Forums - View Single Post

bcbob · 08-01-2016, 02:59 PM

I am trying to set the font size when I convert one of my Azw3 books to pdf for my Sony DPT-S1, which is a large size screen reader that allows writing on documents. However, it only reads pdf's.

I am using Calibre 2.54 on Windows 7 and I cannot figure out how to set the output font size in the dialog box for the Azw3 to Pdf convert. Under "Look & Feel|Fonts" there are a bunch of options but none seem to do the trick.

So far I tried setting the "Base font size" to 12.0 with the "Disable font size rescaling" box cleared, i.e. no check mark, but that does not seem to change anything.

Any suggestions?

08-01-2016, 02:59 PM	#1
bcbob Enthusiast Posts: 38 Karma: 20000 Join Date: Jun 2010 Device: ipad	Azw3 to pdf: increase font size I am trying to set the font size when I convert one of my Azw3 books to pdf for my Sony DPT-S1, which is a large size screen reader that allows writing on documents. However, it only reads pdf's. I am using Calibre 2.54 on Windows 7 and I cannot figure out how to set the output font size in the dialog box for the Azw3 to Pdf convert. Under "Look & Feel\|Fonts" there are a bunch of options but none seem to do the trick. So far I tried setting the "Base font size" to 12.0 with the "Disable font size rescaling" box cleared, i.e. no check mark, but that does not seem to change anything. Any suggestions?