MobileRead Forums - View Single Post

geekmaster · 06-22-2016, 10:46 AM

I just selected "disable diags" and it rebooted (with the USB cable still attached to my PC). I did not see the "** CRP **" text displayed this time. However, it rebooted to diags again, even though I uninstalled CRP (using MRinstaller) and it appeared to succeed.

I will reboot now without the USB cable. Disabling diags again... Hopefully that 97-percent battery report was correct. But then again, it did run well over an hour (how long is unknown at this point in time) with maximum frontlight while drawing an 800x600 image to the screen every 130 milliseconds.

It is at the GUI framework now. Plugging in the USB cable... "Eye Tracker connected" message (RNDIS driver loaded). However, even though the kindle is showing up as a USB networking device at 192.168.15.244, I cannot ping it (permission denied). Nor can I SSH to it. Time to force it in KUAL?

KUAL usbnet says "USBNetwork enabled (usbnet, sshd up)". but not working. Hmm... At least the touchscreen is working at the moment. Unplugging and replugging the USB cable turned on the amber power LED. And now it is green. Fully charged 500mA LiPo battery using the kindle to top off the charge.

But still, some weird behavior to track down in the firmware and installed hacks.

06-22-2016, 10:46 AM	#187
geekmaster Carpe diem, c'est la vie. Posts: 6,433 Karma: 10773670 Join Date: Nov 2011 Location: Multiverse 6627A Device: K1 to PW3	I just selected "disable diags" and it rebooted (with the USB cable still attached to my PC). I did not see the " CRP " text displayed this time. However, it rebooted to diags again, even though I uninstalled CRP (using MRinstaller) and it appeared to succeed. I will reboot now without the USB cable. Disabling diags again... Hopefully that 97-percent battery report was correct. But then again, it did run well over an hour (how long is unknown at this point in time) with maximum frontlight while drawing an 800x600 image to the screen every 130 milliseconds. It is at the GUI framework now. Plugging in the USB cable... "Eye Tracker connected" message (RNDIS driver loaded). However, even though the kindle is showing up as a USB networking device at 192.168.15.244, I cannot ping it (permission denied). Nor can I SSH to it. Time to force it in KUAL? KUAL usbnet says "USBNetwork enabled (usbnet, sshd up)". but not working. Hmm... At least the touchscreen is working at the moment. Unplugging and replugging the USB cable turned on the amber power LED. And now it is green. Fully charged 500mA LiPo battery using the kindle to top off the charge. But still, some weird behavior to track down in the firmware and installed hacks. Last edited by geekmaster; 06-22-2016 at 10:49 AM.