MobileRead Forums - View Single Post

fsiefken · 06-10-2016, 04:26 PM

Hi Franzli, thanks for your feedback. Yes it does have back button on the left side and a forward button on the right side. As most instructions are for the T68 I thought they were more or less the same for the c67. But now I discovered I can only enter recovery mode by pressing and holding the square centered button below "BOOX" when in OFF mode and starting by pressing and holding the power button at the same time (fortunately). It gives a menu I can navigate with the 4 buttons.
I again placed the update.zip (stock C67ML, as I don't have the Carta) from C67ML firmware : 1.7.5_rc1 2016-05-17_14-39_96d1728 (the Carta version gives an error when parsed by the recovery installer as it isn't the correct device).
After a minute or so it says the installation is complete, I then resetted the device but it's still "Starting Up" - for 10 minutes now. I will try older firmware and report back. In the instruction it says it takes a while and to be patient. But you'd think that 200M extraction and install (as I presume it is doing) wouldn't take more then 15 minutes?

06-10-2016, 04:26 PM	#8
fsiefken Junior Member Posts: 6 Karma: 10 Join Date: Sep 2013 Device: none	Hi Franzli, thanks for your feedback. Yes it does have back button on the left side and a forward button on the right side. As most instructions are for the T68 I thought they were more or less the same for the c67. But now I discovered I can only enter recovery mode by pressing and holding the square centered button below "BOOX" when in OFF mode and starting by pressing and holding the power button at the same time (fortunately). It gives a menu I can navigate with the 4 buttons. I again placed the update.zip (stock C67ML, as I don't have the Carta) from C67ML firmware : 1.7.5_rc1 2016-05-17_14-39_96d1728 (the Carta version gives an error when parsed by the recovery installer as it isn't the correct device). After a minute or so it says the installation is complete, I then resetted the device but it's still "Starting Up" - for 10 minutes now. I will try older firmware and report back. In the instruction it says it takes a while and to be patient. But you'd think that 200M extraction and install (as I presume it is doing) wouldn't take more then 15 minutes? Last edited by fsiefken; 06-10-2016 at 05:32 PM.