View Single Post
Old 05-27-2016, 07:41 AM   #101
knc1
Going Viral
knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.
 
knc1's Avatar
 
Posts: 17,212
Karma: 18210809
Join Date: Feb 2012
Location: Central Texas
Device: No K1, PW2, KV, KOA
Quote:
Originally Posted by Yourcat View Post
A tri-d printer would do the job in a few minutes. Deformation of the plastic also sounds promising. Good luck!

I wonder why one would spend time on the OTG / audio dongle. Amazon releases some crap and keeps you busy - at the end of the day no-one will use it.
It is the inside of the edge curve that needs to be flatten out -
I.E: reduce the radius of the edge curve on the inside (by about 1/16 of an inch).
The outside of the curve, the bottom, and the top side are a "don't care" (other than as a matter of appearance).

But people do use USBnetworking.
It is the conflict between USBnetworking and VoiceView that needs to be found and fixed.

(That information is hidden inside of the spoiler of the first post.)

Amazon released the Oasis -
You don't see anyone wasting their time on that product mistake (at least not until they cut the price in half).

Last edited by knc1; 05-27-2016 at 09:21 AM.
knc1 is offline   Reply With Quote