MobileRead Forums - View Single Post

knc1 · 05-23-2016, 02:30 PM

Just now.
I am off to see if this stereo headphone jack is small enough.
Will compare it to the USB adapter I built-in on my own.

Later:
The documentation said this was a low profile, compact, three wire jack.
The adapter cord only requires three leads to be brought out of the Kindle, so this tiny 'headphone' serial port jack should do just fine.
See attached.

No lies there, it is smaller and lower profile than the jim.sh/ftx adapter.
So I **should** be able to get it inside of the PW-3's case.

It may not fit in the same place I used for the adapter on my PW-3 -
because of that step in the frame where the e-ink screen is at.
But it is going into the case somewhere.

05-23-2016, 02:30 PM	#84
knc1 Going Viral Posts: 17,212 Karma: 18210809 Join Date: Feb 2012 Location: Central Texas Device: No K1, PW2, KV, KOA	Just now. I am off to see if this stereo headphone jack is small enough. Will compare it to the USB adapter I built-in on my own. Later: The documentation said this was a low profile, compact, three wire jack. The adapter cord only requires three leads to be brought out of the Kindle, so this tiny 'headphone' serial port jack should do just fine. See attached. No lies there, it is smaller and lower profile than the jim.sh/ftx adapter. So I should be able to get it inside of the PW-3's case. It may not fit in the same place I used for the adapter on my PW-3 - because of that step in the frame where the e-ink screen is at. But it is going into the case somewhere. Attached Thumbnails Last edited by knc1; 05-23-2016 at 03:26 PM.