Thread: Development support hardware
View Single Post
Old 05-20-2016, 12:14 PM   #20
knc1
Going Viral
knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.
 
knc1's Avatar
 
Posts: 17,212
Karma: 18210809
Join Date: Feb 2012
Location: Central Texas
Device: No K1, PW2, KV, KOA
Quote:
Originally Posted by NiLuJe View Post
Well, that was kind of impressive. I don't really know what to say, so I'll keep it short and sweet: thanks, everyone . Promise I'll try to take good care of it and do fun stuff with it .
Well, unless I have my eyes crossed while doing the measurements:

This will fit inside of the PW-3 at the top frame edge:
http://www.digikey.com/product-detai...SJCT-ND/659940

and the matching plug:
http://www.digikey.com/product-detai...01SP-ND/408546

Then do the internal mount similar to:
https://www.mobileread.com/forums/sho...1&postcount=15

I might have to put a small notch in the front/top edge of the case, but this connector **should not** put a bludge in the bezel.
You'll have to turn the Kindle around and look at the top case edge to notice any modification.
knc1 is offline   Reply With Quote