This bit about where busybox ALSO reports a "not found" error when copied to userstore could explain A LOT why I have had so much trouble trying to run MY code on userstore, getting the same error message.
Interestingly, static compiles act different, getting a "seg fault" instead of a "not found". Except of course when they are compiled with codesourcery arm-uclinuxeabi-gcc for win32, where they spit out a mixture of line number, error message, and binary garbage, whether compiled static or dynamic.
Now to find WHICH app runs when copied to a userstore, and where. I need to try using the SD card again -- I am sure I ran something somewhere after copying it on the K1.
I need more coffee to figure this out... But busybox gives a clue, in that it fails too on userstore.
Last edited by geekmaster; 05-10-2016 at 11:24 PM.
|