Thread: K5 FW 5.3.7.3 ignores ENABLE_DIAGS!
View Single Post
Old 05-03-2016, 09:29 AM   #9
knc1
Going Viral
knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.
 
knc1's Avatar
 
Posts: 17,212
Karma: 18210809
Join Date: Feb 2012
Location: Central Texas
Device: No K1, PW2, KV, KOA
Quote:
Originally Posted by NiLuJe View Post
Don't some of those ship with a nice "USB Mode" label near some pins somewhere on the board?
Yes, all i.MX6 (except Oasis) have clearly labeled switch pad locations (less the switch).

I have pictures, PW2, PW3, KT2 posted somewhere (in my PW3 and/or KT2 treads).

Those are the ones that I hadn't tried, the ones I was going to control with the control outputs of the Jim.fx adapter board.

Now with the info GM quoted, it should be a piece of cake to test it they are working in consumer boards (the other pad outlines work as labeled).
knc1 is offline   Reply With Quote