Quote:
Originally Posted by abarthch
I just removed the outer frame to uncover the sensor. It looks fine but when I put pressure on it, my PW instantly wakes up from standby. When I release the pressure, standby comes back on. I don't think that's supposed to happen, unless my small finger is magnetic (No, I don't have a prostetic  ). |
You where correct, a loose connection.
If you have, or have access to, a hot air soldering system, first try to just 're-flow' the existing solder without re-moving the part.
Careful where the hot air goes - you don't want to un-solder anything nearby.