Quote:
Originally Posted by Leonatus
Hi Toxaris, it's me again.
This time, before conversion, I set the document language to "deutsch"; the box in front of this option was checked, as well as the box to save the settings on exit.
when I started the converversion, it showed the same result as yesterday: hanging on step 2/15: set language.
I noticed that the setting of the language in the "preparation" section had not been saved on exit.
I unchecked the box in front of the option, but the result was the same.
Now I don't know what to do.
|
I have found the culprit. I had to make a change to the languages due to another function. In the past, only a handful of languages could be selected. Now all supported in Word languages can be selected. However, the translation from the old system to the new system did not work as it should. I have adapted the routine for this, so it should work now. I will try to upload this today.
However, a change in language should have been saved and this works fine. Actually, a change of language in the settings (preparation tab) should also fix this.