Thread: Run Calibre in Debug Mode Output to File
View Single Post
Old 03-07-2016, 04:50 PM   #1
toomuchreading
Groupie
toomuchreading once ate a cherry pie in a record 7 seconds.toomuchreading once ate a cherry pie in a record 7 seconds.toomuchreading once ate a cherry pie in a record 7 seconds.toomuchreading once ate a cherry pie in a record 7 seconds.toomuchreading once ate a cherry pie in a record 7 seconds.toomuchreading once ate a cherry pie in a record 7 seconds.toomuchreading once ate a cherry pie in a record 7 seconds.toomuchreading once ate a cherry pie in a record 7 seconds.toomuchreading once ate a cherry pie in a record 7 seconds.toomuchreading once ate a cherry pie in a record 7 seconds.toomuchreading once ate a cherry pie in a record 7 seconds.
 
toomuchreading's Avatar
 
Posts: 180
Karma: 1720
Join Date: Feb 2009
Location: Canada
Device: PRS-T1, Kobo Libre Color
Run Calibre in Debug Mode Output to File
I'm having an intermittent problem, and wold like to start up Calibre every time in debug mode so I can post what's going on.

Are there any parameters that I can add to my shortcut to have Calibre start up in debug mode, like it does when you restart Calibre in debug mode from preferences?

I'd like to run right from the get go in debug mode with the output going to a text file, since, every time I restart Calibre in debug mode, the problem goes away. It always goes away when I restart Calibre, whether in debug mode or not, so I'd like to start up in debug mode to begin with.

I'd like to try to capture a few failures to see what is going on if I can...
toomuchreading is offline   Reply With Quote