View Single Post
Old 02-04-2016, 09:29 AM   #10
knc1
Going Viral
knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.
 
knc1's Avatar
 
Posts: 17,212
Karma: 18210809
Join Date: Feb 2012
Location: Central Texas
Device: No K1, PW2, KV, KOA
Quote:
Originally Posted by abarthch View Post
Shame on me

I didn't find a manual with the PL2303 but I avoided that problem by making a level shifter circuit. Now when I connect everything, boot up the Kindle and measure the voltage on the Kindle I get
Tx - GND: 1.8v
Rx - GND: 0.9v
The Rx-LED on the PL2303 flashes every so often.

After that I followed this tutorial on how to set up minicom but where it says:

I don't get anything on the minicom screen. I have set the correct device (on my machine it's also ttyUSB0 like in the tutorial), 115200 bps and no flow control. I have tried with and without external power supply (usb micro).
Remove the Rx-LED as the warning in the level shifter recommends.
knc1 is offline   Reply With Quote