Thread: Unbrick a PW3 (Fastboot)
View Single Post
Old 01-03-2016, 01:31 PM   #32
knc1
Going Viral
knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.
 
knc1's Avatar
 
Posts: 17,212
Karma: 18210809
Join Date: Feb 2012
Location: Central Texas
Device: No K1, PW2, KV, KOA
Quote:
Originally Posted by nigredo View Post
Thanks knc1,
I found your photos.

By now I'm practicing with my old k4nc, using imx_usb_loader to set the kindle in fastboot mode. But it seems that there are problems flashing the main fs (too big).

So I'm considering alternatives, for example try to load the official uboot for imx6 in ram (don't know if it is possible) because this version,
reading the freescale forum, is apparently able to run commands on the device like a shell (sort of) using other utility named utp_com.
The K4 is not an I.MX6 (only newer than PW-1 are I.MX6).
It is one of the i.MX5 series (mx50? mx53? - not sure).

Check the Wiki master index for K4, and then that section for a teardown - at least one of them will mention part numbers.
knc1 is offline   Reply With Quote