Quote:
Originally Posted by knc1
If you have to ask that, you haven't read what is posted about serial jailbreaking here (this isn't the only thread on the topic).
Jailbreaking a Kindle over the serial port requires a person who reads the directions.
Seriously, it really, really does require reading and following directions.
So don't even try this yourself.
|
Thanks for your reply.
If you think I don't read this directions, you're wrong, I have read it many times, and all the relative post but I have dificulty on finding a break board mentioned in this thread.
I known the directions say that if I use 3.3v or 5v IO pin, it will destroys my chip, but in this picture, the IO pins is set in 1.8v-3.3v
and I don't know if the 3.3v signal in
this board is the same as 1.8-3.3v in Jim's Board
If not, can I reduced the voltage from 3.3 to 1.8 to use (by using a diode, or...)
(Sorry for my bad English)