|
I don't know for yours but on my PRS-505, the rubber pads located near the spine seem a bit too high and don't actually touch anything when the plexiglas screen is in position. The plexiglas screen only touches the right edge of the reader's screen.
Therefore, the plexigas screen doesn't fall flat on the 505's screen and it creates a little gap between the plexiglas and the reader's screen on the left part of the screen.
As the plexigas screen is frosted on the lower side to diffuse the light on the reader's screen, the pages are very readable on the right side but slightly blurried on the left part.
Do you have the same problem on yours?
Sébastien.
|