View Single Post
Old 10-05-2015, 09:23 PM   #4
porkupan
Fanatic
porkupan ought to be getting tired of karma fortunes by now.porkupan ought to be getting tired of karma fortunes by now.porkupan ought to be getting tired of karma fortunes by now.porkupan ought to be getting tired of karma fortunes by now.porkupan ought to be getting tired of karma fortunes by now.porkupan ought to be getting tired of karma fortunes by now.porkupan ought to be getting tired of karma fortunes by now.porkupan ought to be getting tired of karma fortunes by now.porkupan ought to be getting tired of karma fortunes by now.porkupan ought to be getting tired of karma fortunes by now.porkupan ought to be getting tired of karma fortunes by now.
 
porkupan's Avatar
 
Posts: 556
Karma: 1057213
Join Date: Sep 2006
Location: North Eastern U.S.
Device: Sony Reader
It's been quite a while since you reported this problem, so hopefully you've already addressed it in some fashion.

A couple of weeks ago I started experiencing the same problem with my PRS-T3, which I bought on eBay. Since the Reader has been discontinued here in the States, and PRS-T3 had never been release here, Sony refused to fix it, telling me I needed to ship the Reader back to the country where I bought it to be fixed.

Well, to make a long story short, you are better off fixing it yourself. A Russian technician who specializes in repairing ebook readers told me that the common point of failure is usually the overcurrent protector in the reader's battery. When an eInk screen does a full refresh, the current draw is often high enough to trip the overcurrent fuse, and cause the device to shutdown. After a while these fuses "dry up", and start tripping all the time.

What you need to do it open up the Reader and get to the battery. Open the white paper sticker on the battery, observe that one of the contacts is attached to the little board via a small chip (that's the overcurrent protection device). Bypass it by either soldering a wire between the battery contact and the board, or just by dropping a big drop of solder that reaches across the fuse.

Then put the sticker back onto the battery, and make sure the battery still works. In the worst case you may have to buy a new battery on eBay, and solder it to the board. But my Reader seems fine after the bypass.

Last edited by porkupan; 10-05-2015 at 09:30 PM. Reason: grammar and spelling
porkupan is offline   Reply With Quote