Quote:
Originally Posted by rkomar
Heating the glass substrate unevenly sounds like a recipe for disaster if it is like ordinary plate glass (i.e. expands when heated). Does anyone know if the substrate is made with glass with a low expansion coefficient (like Pyrex)?
|
Yeah, just to clarify I'm thinking you'd only need to heat the far edge of the device (i.e. where the page up/down buttons are) in order to get the soft-plastic frame cover off. IIRC there's some type of glue/tape used on the left edge, so this would just be a small amount of heat. From there you might then be able to find the latches/screws.
Still, you need to be careful if there's any tape around the edges where the actual eink screen is. If it's like the nooks, it's a very thin/fragile tape.