Quote:
Originally Posted by jbaumann
The simulation seemed to work ok i.e., I got the connect dialog and pressed it in time (ca. 1 second after it popped up). Then a few seconds it showed the "connected" screen.
Instead of the progress bar I got this short flash and then the normal Nickel screen. Before starting this experiment I already had some books on the reader. But Nickel showed none of them. I thought the database had been be corrupted.
After a reboot though the database was ok and Nickel again knew about the books. Plugging in and then unplugging the reader brought up the progress bar and Nickel had, after finishing the scan, all the books accessible.
Cheers, Joe
|
In any case, the simulation did not have the wished for effect, namely processing the new books. Instead nickel processed them only after the real usb connect and disconnect sequence.
Strangely, it can also happen that nickel does not process newly added books after a real connect/disconnect too. I have seen this some weeks ago happening to my wife's Glo, which is running on the original firmware without any modifications. After copying books, ejecting and disconnecting, nickel did not process the books. Even after repeated connecting/unconnecting and powering on and off nothing happened. Then after some further trials, all of a sudden nickel processed the books.