View Single Post
Old 07-22-2015, 07:12 PM   #8
davidfor
Grand Sorcerer
davidfor ought to be getting tired of karma fortunes by now.davidfor ought to be getting tired of karma fortunes by now.davidfor ought to be getting tired of karma fortunes by now.davidfor ought to be getting tired of karma fortunes by now.davidfor ought to be getting tired of karma fortunes by now.davidfor ought to be getting tired of karma fortunes by now.davidfor ought to be getting tired of karma fortunes by now.davidfor ought to be getting tired of karma fortunes by now.davidfor ought to be getting tired of karma fortunes by now.davidfor ought to be getting tired of karma fortunes by now.davidfor ought to be getting tired of karma fortunes by now.
 
Posts: 24,905
Karma: 47303824
Join Date: Jul 2011
Location: Sydney, Australia
Device: Kobo:Touch,Glo, AuraH2O, GloHD,AuraONE, ClaraHD, Libra H2O; tolinoepos
Quote:
Originally Posted by cornishnick View Post
I can't find the book If I use the send to device (rather than save to disk) but it will show in the explorer if I use the drag and drop method.

Link to the plug board page. Doesn't seem to be anything on there, can you link to the preferred settings at all please? The only thing like this I've done is added the shelves column and setting.
Ok, you haven't made any changes there. So, it is the device driver that is configured wrong. My last post had instructions for getting to this. I'm at work at the moment, so can't take a screenshot to show you my configuration. But, when you see the configuration take a copy of whatever is in the "Save template" field. The replace it with:
Code:
{author_sort}/{title} - {authors}
That is a good default. Save the change and restart calibre when prompted. After that, the send should work.

And please post what was in the field. I'm curious about what it was.
Quote:
I've misunderstood about the log in/out mentioned above. Turned wifi on and device said it needed to update so clicked to install that and have been stuck on the updating squares thing for some time now so not sure what's going on now.
Quote:
Originally Posted by cornishnick View Post
The update froze and a full factory reset was performed :-(

Still having the same problem when trying to send to device
That isn't surprising as the problem is in the configuration of calibre.

If what I said above doesn't work, then I need to see a debug log when the device is sent and you send a book. I gave instructions for that earlier. The log shows all everything that goes on when calibre talks to the device. I can usually work out what is going wrong from this.
davidfor is offline   Reply With Quote