MobileRead Forums - View Single Post

tweq112 · 06-12-2015, 05:39 AM

Hi, no problem. I'm also pretty busy here. In the end I was actually able to get the keyboard working without doing anything to the kernel (so there goes my motivation for learning to configure one). I'm not 100% what the problem was yet, but I think what I did was

1. Power off the M92
2. Plug the hub in (with the keyboard connected) and plug it in to the M92
3. Power up the M92, boot Obuntu and run crazydog's script

Before I was trying to connect the keyboard to the M92 after it had already been powered on. I'm not 100% that's what made the difference, but I'll give it another try in the next couple days. I think it's a bit faster than with VNC, but that VNC lag wasn't too bad for me... What I appreciate about it is just being able to use it without an additional pc.

So, yeah, thanks again for confirming that you had it working. Without knowing that I might have given up on it. Next stop, schoneschein's button fix.

06-12-2015, 05:39 AM	#190
tweq112 Junior Member Posts: 8 Karma: 10 Join Date: Aug 2006 Location: South Korea	Hi, no problem. I'm also pretty busy here. In the end I was actually able to get the keyboard working without doing anything to the kernel (so there goes my motivation for learning to configure one). I'm not 100% what the problem was yet, but I think what I did was 1. Power off the M92 2. Plug the hub in (with the keyboard connected) and plug it in to the M92 3. Power up the M92, boot Obuntu and run crazydog's script Before I was trying to connect the keyboard to the M92 after it had already been powered on. I'm not 100% that's what made the difference, but I'll give it another try in the next couple days. I think it's a bit faster than with VNC, but that VNC lag wasn't too bad for me... What I appreciate about it is just being able to use it without an additional pc. So, yeah, thanks again for confirming that you had it working. Without knowing that I might have given up on it. Next stop, schoneschein's button fix.