Quote:
Originally Posted by tshering
Could you give me some more information. I understand you tried to install only the first of the three updates. Right? Before you installed it did you start nickel? If yes, did you exit nickel via the png and did KSM then still work?
When you installed update 1 and the tap&close page appeared, tapping at the middle of the screen had no effect at all. Did you tapping all over the place? Sure the bottom menu did not appear but did something else happen? Was there a screen refresh?
That means you forced the device to power off. After powering on again, you waited for some time but there was only a white screen. Was that the sequence of events?
|
Hey tshering, It doesn't matter if I install one or all three. When I tell it to handle the updates the screen rotates 90 degrees CCW and I can tap the centre to see the close option, but the GloHD is not recognizing the tap to the bottom. This is most likely because the software doesn't realize the screen has been moved. I have tried taping the centre of the screen in normal orientation, incase the touch orientation had stayed normal, but no joy.
I did let nickel boot before the updates were loaded onto the device, and yes when I started it the second time it went to a blank screen and stayed there indefinitely. I had to do a hard reboot. The light, under the power button, kept flashing but there was no activity on the screen.
In the end I had to pull the sd card and re-flash it.