Quote:
Originally Posted by flip1314
I have a Glo HD. KSM installs fine, but when I go to process update 1 the geometry flips 90 degrees clockwise on the "tap&close" page and I cannot move forward from there.
|
Could you give me some more information. I understand you tried to install only the first of the three updates. Right? Before you installed it did you start nickel? If yes, did you exit nickel via the png and did KSM then still work?
When you installed update 1 and the tap&close page appeared, tapping at the middle of the screen had no effect at all. Did you tapping all over the place? Sure the bottom menu did not appear but did something else happen? Was there a screen refresh?
Quote:
Originally Posted by flip1314
Ya, I tried that stuff before I got your message. I had to pull the SD card and remove the kbmenu folder to get it working again. It just became a blank screen and would no longer boot nickle.
|
That means you forced the device to power off. After powering on again, you waited for some time but there was only a white screen. Was that the sequence of events?