|
I checked, custom 15 values have no problems. I didn't have any problems with your 10 values too but I only used it once before customizing. I checked your 10 values again, same problem persists. My not having problems that one time was an anomaly probably.
Only reason I am using 10 values is to bypass aesthetic problems with set top and bottom margins (Yes, I realize that I am just nitpicking). I changed to this now:
# 15 values for replacement:
replace_float = 604A48, 1.0, 0.7
replace_float = 604B10, 1.05, 0.75
replace_float = 604B18, 1.07, 0.8
replace_float = 604B20, 1.1, 0.825
replace_float = 604A50, 1.2, 0.85
replace_float = 604B28, 1.35, 0.875
replace_float = 604A58, 1.5, 0.9
replace_float = 604B30, 1.7, 0.925
replace_float = 604B38, 1.8, 0.95
replace_float = 604A60, 2.0, 0.975
replace_float = 604B40, 2.2, 1.0
replace_float = 604B48, 2.4, 1.25
replace_float = 604B50, 2.6, 1.5
replace_float = 604B58, 2.8, 1.75
replace_float = 604A68, 3.0, 1.1
This values solve the margin problems too, every step makes a difference in lower glyph sizes.
|