Calibre scanning all of 1TB Dropbox
So, I hooked up my new Galaxy Tab S to my PC as a Media Device (just happens) and then started Calibre. Calibre recognized the new device and asked if I wanted to set it up, and I said Yes.
Then it started scanning for books on the device. The device had Dropbox installed and apparently logged in, so Calibre happily started scanning through the 300 GBs of my 1 TB Dropbox. Life is too short.
I tried to kill it politely, and Calibre refused to stop. So I killed it ugly, closed the Dropbox and rebooted the tablet. After that Calibre was able to complete.
There has to be a better way: Calibre should not seek to scan a remote Dropbox without specifically asking first.
Last edited by caseym54; 05-03-2015 at 02:03 PM.
|