|
@stanlefor: Sorry, I missed this one last night.
The Kobo Aura HD is accessed with the KoboTouch driver. Assuming you haven't installed the extended driver. If you have installed the extended driver, please disable it and retest.
The questions and suggestions I can think of are:
- Is this new behaviour? Has it worked in the past and this has just started? Or is it a new device and it is the first use?
- After calibre closes, can you access the device? That is browse its drive or copy a file to it.
- If you don't have calibre running, can you access the drive when it is first connected?
- When the device is connected, calibre runs three jobs. Which one gets run?
- As well as what Kovid suggests, change the metadata management to manual. This is on the "Sending books to devices" page. That cuts out on of the connection startup jobs. It is also the one that is most likely to have problems.
- What OS?
- As you didn't say anything about them, I assume there were no error messages.
- Is the device working OK? If you power off and on do you lose books or the reading status of books?
Running calibre in debug mode might also tell us something. Usually I recommend restarting in debug mode, connecting the device and waiting for the jobs to finish. Then closing calibre and the debug log is displayed. But, I'm not sure if that will happen in this case. Calibre will display the full path for the debug log when it restarts, you should take note of this to find it after calibre closes. The full debug log will tell me a lot about what is happening.
|