Could someone do me a favor and post a screenshot, or just type out the relevant info, regarding the firmware used in the Afterglow 2? (specifically the version sold by Amazon, via Arta Tech)
I messed some things up with the Onyx Launcher by following some of the instructions for debloating the T68, which caused the OnyxLauncher has stopped window to pop up each time I went to the home screen. Annoying, but I had ADW launcher on there so not a big deal. I went to factory reset to fix it up but unfortunately all it will do now is boot into home screen and in Polish say unfortunately, the onyx launcher has stopped. And now I can't do anything with it! I tried downloading the C67 firmware from here (
http://www.onyx-international.com/in...1-6-5-20141104), but apparently that is not correct as when I try to install it from my SD card it says
assert failed: getprop)"ro.product.device") == "C67ML" || getprop("ro.build.product") == "C67ML"
So I'm assuming the version of the Afterglow 2 being sold on Amazon does not match up exactly with the C67ML firmware being distributed by Onyx International (even though when I plug in to my computer what shows up is "Arta Tech C67ML").
Anyways, long story short, if someone who also has an afterglow 2 from amazon could go to "About device" under settings and take a screenshot, or post the text from build info (example from screenshot of c65 in manual below), then I would have a better idea of what to look for!
Thanks!
