View Single Post
Old 01-07-2015, 02:23 PM   #11
Kafkarudo
Member
Kafkarudo began at the beginning.
 
Posts: 14
Karma: 10
Join Date: Jan 2015
Device: Kindle
1) i don't know in which partition the duokan was installed. I just did a usual installation.
2) I didn't remove duokan, It was workin fine, until I unpluged the usb from my pc without extract it first. So after that duokan began to behave strange, I did a reboot, and that's it.
3) I flashed the diags kernel with the file that I get from this site. Diags_kernel-4-4-0. Then the partition mmcblk0p2.img, and the kernel with the 4.0 and recently with 4.1.
I did the flash with fastboot, and every time, the flash give me a confirmation.
4) with Mfgtool I can switch between Normal, diags, and fasboot. If i set it to normal, the load bar get stuck always in the same place.
If a set it to diags, the screen get broken.
5) in normal mode, the kindle is detected as a flash drive but with 0bytes.
md5 mmcblk0p2.img.tar 9CECDF379830BEB0A63AD416B05FDEAC
md5 kernel-4-0-0 1BDF362E0FA4B4BFC3D9B5AD497A0786
md5 diags_kernel-4-0-0 311BAF97839818CCBE38EA1455154DC8
md5 extracted diags_kernel 3566D91F123E609B6A1AA8E679D65BFC

Last edited by Kafkarudo; 01-07-2015 at 02:29 PM.
Kafkarudo is offline   Reply With Quote