Quote:
Originally Posted by JSWolf
When I use "Show one group at a time", how do I switch from one group to the next?
|
Find Duplicates->Next/Previous result. I have them shortcutted to ctrl/alt/right & left respectively.
Quote:
Originally Posted by LDMartin1959
BetterRed, I am searching for dups in a single library (and if it makes a difference, I only have the one), binary compare, show all groups at once with highlighting, sort groups by number of duplicates.
|
I believe binary compares can be slow if there are lots of them - suggest you peruse this thread for discussion. I don't normally use Find Duplicates binary compare, but I just did two tests. The PI found a duplicate PDF of a 19th century novel, that I added into a Yale Law 'book' on UN R2P provisions, took a few seconds - this was a small test library. A second test in a library of ~8000 'books' found three binary duplicates that I need to look into - this took a couple of minutes.
BR