[Ken Maltby]

The problem is that the design of the AuraHD enclosure has the Bezel, and a layer of IR transmissive black plastic attached to it, as a critical part for the IR touchscreen's operation. The IR plastic must be held in tight to the surface of the screen. I don't see how applying it to the outside of the case could be effective. Silicone sealer has considerable bonding capability, and can be slit apart without breaking the bezel or the rest of the case. So, it would be a good choice for "gluing" the bezel to the case. You would open the case ( and do any upgrades while you have it open ) then apply the sealer as a bead all around the edge of the case. Reattaching the bezel and putting some weight on the device while it sets, should work.

I am adding an adapter to connect the internal uSD to a uSD socket, to create the same kind of slot as the external uSD. When the adapter cable gets here I'll do up a post like I did for the temporary "Quick" one I did already. With one of these in place the only reason to open the case again might be to replace the battery.

Luck;
Ken