|
The errors about /proc/keypad are not fatal, you can ignore them. The single important error here is "Unable to connect to VNC viewer". If you run VNC display :1 on the RasPi, you need to run "/mnt/us/kindlevncviewer/kvncviewer.sh 192.168.15.1:1". On the RasPi, you'll likely want to switch to x11vnc at some point if you want to use keyboard/mouse connected to it. For now, vncserver (Xvnc) will work fine. I hope the space between ":" and "1" is just a quotation error?
Errrm - you *did* set up USB networking and tested it, right? So you're sure the IP addresses are set up properly and you can make connections? Checked the firewall, as twobob suggested?
|