Quote:
Originally Posted by Thanks4Kubrick
- - - -
My problem was two fold:
1) I hit the x) exit push (right or left I forget), but it wouldn't exit.
2) It would freeze a lot in Diag Mode, failing to accept user input.
- - - -
|
There where firmware diags versions on the K3 that would not recognize the "exit" selection from the display.
The diags menu is repeated on the serial port, on that connection, it would recognize the "exit" selection.
(I own a K3 that is that way.)
There is a possibility that some of the K4's also had this problem.