View Single Post
Old 04-25-2014, 01:37 PM   #15
tshering
Wizard
tshering ought to be getting tired of karma fortunes by now.tshering ought to be getting tired of karma fortunes by now.tshering ought to be getting tired of karma fortunes by now.tshering ought to be getting tired of karma fortunes by now.tshering ought to be getting tired of karma fortunes by now.tshering ought to be getting tired of karma fortunes by now.tshering ought to be getting tired of karma fortunes by now.tshering ought to be getting tired of karma fortunes by now.tshering ought to be getting tired of karma fortunes by now.tshering ought to be getting tired of karma fortunes by now.tshering ought to be getting tired of karma fortunes by now.
 
Posts: 3,489
Karma: 2914715
Join Date: Jun 2012
Device: kobo touch
Quote:
Originally Posted by SHunter101 View Post
Hi Tshering:

Your method is way easier than the one above (post 12). However, I get an error, see attached file. When I remove the 15 line spacing code and use the 10 line spacing code, I get a similar error.

SHunter
I tried again with both line spacing patches. And both run without error. Is it possible that something happened to your configuration file, or that you use a libnickel.so.1.0.0 that has already been modified?

Edit: Since the error is at 676F68, I wonder why GeoffR writes twice at this point:
Code:
replace_bytes = 676F68, 86 EE 1D A3 D3 E9 00 23, 00 00 00 00 00 00 F0 3F
...
replace_float = 676F68, 1.0,  0.7
But this does not explain, why it is working for me, and not for you. Or did you by chance change one of these two lines? Since this would result in an error.

Last edited by tshering; 04-25-2014 at 02:01 PM.
tshering is offline   Reply With Quote