Thread: prs-505 or 700?
View Single Post
Old 10-28-2008, 11:12 AM   #8
Dave Berk
Fanatic
Dave Berk can fool all of the people all of the time.Dave Berk can fool all of the people all of the time.Dave Berk can fool all of the people all of the time.Dave Berk can fool all of the people all of the time.Dave Berk can fool all of the people all of the time.Dave Berk can fool all of the people all of the time.Dave Berk can fool all of the people all of the time.Dave Berk can fool all of the people all of the time.Dave Berk can fool all of the people all of the time.Dave Berk can fool all of the people all of the time.Dave Berk can fool all of the people all of the time.
 
Dave Berk's Avatar
 
Posts: 574
Karma: 138556
Join Date: May 2006
Device: PRS505
Quote:
Originally Posted by gwynevans View Post
Mind you, while I don't know which one's you saw, I saw one that came to that conclusion based on the assumption that because the 700 had a touch-screen/side-LEDs, it would have an additional layer of glass/plastic that would make the screen less readable. It wasn't stated, but the impression I got was that the author'd not actually seen a 700 & was just deducing a change.
The Touchscreen is below the Eink substrate. So it was stated few times in the PRS700 forum. Of course nothing is known for sure yet

What I'm basing my opinion on is this and this.

Last edited by Dave Berk; 10-28-2008 at 11:23 AM.
Dave Berk is offline   Reply With Quote