[Catsnkites]

ok, what did I do now ...

I have a book ... it was originally from amazon. I converted it to epub and then converted that to kepub. I now have three versions of the same book. I put the epub and kepub on my Glo so I could see the differences.

When I choose the kepub and select a chapter, it locks up the Glo. (it's hung on "loading Chapter Nine") I have to restart it and I can't always get out of the book. Sometimes it goes to the correct page in the book and sometimes it stays on loading the chapter until I restart it again and choose another book. What gives?



So ... if I use the Touch Driver, do I have to specifically tell it to transfer the kepubs, or does it default to kepub if it's there and use epub if it isn't?

If I use the extended driver, I don't have to convert to kepub because it does it automatically on transfer ... meaning my Calibre library is smaller ...

Are the resulting kepubs in both cases identical?


And one last question (if you believe that I've got some ocean-front property in Arizona to sell you!):

I installed the Kobo desktop to set up the Glo. I use Calibre to manage the device. Can I un-install the Kobo desktop? I suspect it's why my Glo will not properly eject.