MobileRead Forums - View Single Post - Glo Calibre/Kobo Glo "error communicating with device."

Ripplinger · 11-28-2013, 03:01 AM

Is there anyone using WinXP and AMD that has this problem to know if it's any better or worse with the newest firmware versions of 3?

I still haven't had this problem happen again since downgrading to 2.4.0. I had to do a factory reset only once in that time but it wasn't due to this error at all (and for some reason, downgrading back from 2.10 was very difficult this time around, so I'm more reluctant to load 3 just to experiment). But I've read about a few recent improvements in 3 where I might live with the horrid homepage tiles for them, but not if I can't use Calibre on my main PC again with it.

11-28-2013, 03:01 AM	#70
Ripplinger 350 Hoarder Posts: 3,574 Karma: 8281267 Join Date: Dec 2010 Location: Midwest USA Device: Sony PRS-350, Kobo Glo & Glo HD, PW2	Is there anyone using WinXP and AMD that has this problem to know if it's any better or worse with the newest firmware versions of 3? I still haven't had this problem happen again since downgrading to 2.4.0. I had to do a factory reset only once in that time but it wasn't due to this error at all (and for some reason, downgrading back from 2.10 was very difficult this time around, so I'm more reluctant to load 3 just to experiment). But I've read about a few recent improvements in 3 where I might live with the horrid homepage tiles for them, but not if I can't use Calibre on my main PC again with it.