Quote:
Originally Posted by DennisH
ebina1, and others who have opened a PW2,
My PW2 should arrive in the next day or so and I am keen to jailbreak it.
After viewing all the excellent pictures it seems to me that it should be possible to drill 2 (or 3 if necessary for an earth) 0.5mm or so holes in the back of the case directly above the terminal points to insert some wire probes or pins just long enough to load the jailbreak. Alternatively, a single 5mm or 6mm hole (which could be later filled with a solid grommet of some sort) would provide access to both terminals. I assume there will be an earth somewhere on the usb plug so only the tx and rx should need to be probed.
The success of such an arrangement would obviously depend on the accuracy of the hole(s) location. Firstly, I would be interested in any comments you may have re feasibility, and, secondly, if you would be able to provide some measurements or a template of how/where to locate the holes(s).
Also, did you use the PW1 jailbreak or some other jailbreak.
Thanks
|
Your idea got me to rewatch the PW2 dismantling video (link below) which indeed shows that the 3 serial connections on the board (in the rectangle named P800 SERIAL DEBUG) appear to be located just under the back cover. Now instead of drilling 3 holes which would require such extreme location precision why not just make a small opening in the cover to access this area, like an X-Acto cut rectangle which could be put back in place once the JB was done.
[Added Later] Having said all that, can anybody recommend a good "spudger"? I'm not afraid to dismantle the PW, only reason I'm reluctant is my fear of damaging the part of the case that would show even when covered.
https://www.mobileread.com/forums/sho...=222229&page=8