|
MrBook69,
this might perhaps not help in your case. I tell it anyway.
I once was in a similar situation. I tried to install a modified libnickel.so.1.0.0. The squares started dancing and after a while they stopped. Powering off and on, and also a paper clip reset, took me exactly to the same point. After powering on and off several times, I realised that the device was responsive to touch. When the squares stopped dancing and I touched the screen, they started again to dance. I pressed the home button and the home screen appeared for a moment, but was again replaced by the dancing squares. I plugged the device to the PC, and the connection screen showed for a short time and was replaced again by the dancing squares. I tapped at the place where the "connect" button used to be, and the device connected to the PC. I installed the original libnickel.so.1.0.0 and it stuck again at the dancing squares. I repeated the whole procedure and everything was o.k. I don't know how to explain this. Then I re-installed my modified libnickel.so.1.0.0 (exactly the same file as at the beginning, I didn't change anything) and everything went without problem.
|