Thread: How do I enable usb networking?
View Single Post
Old 07-17-2013, 05:34 PM   #4
knc1
Going Viral
knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.
 
knc1's Avatar
 
Posts: 17,212
Karma: 18210809
Join Date: Feb 2012
Location: Central Texas
Device: No K1, PW2, KV, KOA
Quote:
Originally Posted by wallacemckart View Post
Thank you knc1 for your advice I just want to to install USB networking in the "main" mode.

First I Jailbreaked at 5.3.5 then updated to 5.3.6 and installed dev certificates,rescue pack.
Sounds good so far.

After installing the USB networking package linked to above (yes, I know that thread title is for the earlier JB but the USB network package attached is the correct one for current versions).

You may also want to install the KUAL launcher with the helper pack of buttons, which includes the USB button.
Not required, but handy for turning on/off the screensaver and the USB networking.

The prerequisites package in the KUAL post contains everything needed to not only run KUAL, but to run anything here.
So you will gain that also when you install the KUAL prerequisites.
knc1 is offline   Reply With Quote