Thread: Flash original Amazon firmware to a Kindle (in native Linux, without Kubrick)
View Single Post
Old 07-15-2013, 08:17 AM   #4
knc1
Going Viral
knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.
 
knc1's Avatar
 
Posts: 17,212
Karma: 18210809
Join Date: Feb 2012
Location: Central Texas
Device: No K1, PW2, KV, KOA
Quote:
Originally Posted by Synthead View Post
Is there a way to "Select Boot" without Windows software?
1) What O.S. are you running? Your original post did not mention that.
O.S. mentioned in the title, my bad.

2) There is no need to run Kubrick in a VM. In fact, it may not run properly in a VM.
Just run it on the bare hardware. Since it is a memory-resident (only) O.S. image, it does not matter what O.S. the bare hardware (was) running before you booted it with Kubrick.

Start by reading the original directions:
https://www.mobileread.com/forums/sho...d.php?t=170929
Last edited by knc1; 07-15-2013 at 08:22 AM.
knc1 is offline   Reply With Quote