View Single Post
Old 06-10-2013, 12:42 PM   #47
Ken Maltby
Wizard
Ken Maltby ought to be getting tired of karma fortunes by now.Ken Maltby ought to be getting tired of karma fortunes by now.Ken Maltby ought to be getting tired of karma fortunes by now.Ken Maltby ought to be getting tired of karma fortunes by now.Ken Maltby ought to be getting tired of karma fortunes by now.Ken Maltby ought to be getting tired of karma fortunes by now.Ken Maltby ought to be getting tired of karma fortunes by now.Ken Maltby ought to be getting tired of karma fortunes by now.Ken Maltby ought to be getting tired of karma fortunes by now.Ken Maltby ought to be getting tired of karma fortunes by now.Ken Maltby ought to be getting tired of karma fortunes by now.
 
Ken Maltby's Avatar
 
Posts: 4,466
Karma: 6900052
Join Date: Dec 2009
Location: The Heart of Texas
Device: Boox Note2, AuraHD, PDA,
Quote:
Originally Posted by 5thWiggle View Post
Run some waxed dental floss gently between the battery and the pcb as close to the battery as possible. This works for double sided tape and most of the low tack, soft gel hot melt glues used in electronics. Will not work for epoxy or hard gel hot melts, but you don't often run into those holding a battery because of they set too quickly, and have the possiblity of damaging the pcb.
Thanks much, good to know.

I might try that some day. What do you think about adding some glue remover
to the dental floss? (Might not work on the waxed though.)

Luck;
Ken

Last edited by Ken Maltby; 06-10-2013 at 12:46 PM.
Ken Maltby is offline   Reply With Quote