MobileRead Forums - View Single Post - Problem after Kubricking: can't exit DIAG-pcbId and DSN don't match

knc1 · 05-22-2013, 02:06 PM

If you need support with an off-site hack - -
The place to get help is from that other site.

- - - -

Did you try just deleting the "ENABLE_DIAGS" flag file and re-booting?

Kubrick does not touch that part of storage which holds the device-specific data.
Are you certain that you could enter and exit diag mode **before** you kubrick'd it?
I.E: It may not be kubrick's fault.

05-22-2013, 02:06 PM	#2
knc1 Going Viral Posts: 17,212 Karma: 18210809 Join Date: Feb 2012 Location: Central Texas Device: No K1, PW2, KV, KOA	off-site hacks If you need support with an off-site hack - - The place to get help is from that other site. - - - - Did you try just deleting the "ENABLE_DIAGS" flag file and re-booting? Kubrick does not touch that part of storage which holds the device-specific data. Are you certain that you could enter and exit diag mode before you kubrick'd it? I.E: It may not be kubrick's fault.