Quote:
Originally Posted by DNSB
When I look at my Aura, between the bezel and the screen, there is a narrow space which is set a millimeter or so back from the edge of the bezel. I had assumed that the plastic on the back of the gap was an IR filter which covers the emitters on one side and the receivers on the other side of the Aura (ditto for top and bottom of the screen). I have noticed that if anything gets into there (cat hairs, for instance), the touch screen can behave very strangely.
Regards,
David
|
Well, that must be the problem, my bezel has no such "gap" and it is all
one piece of plastic. There is no observable space between the top sheet
of plastic and the bezel, in fact there is a layer of double sided tape that
secures the inside edge of the bezel to the top layer. It would be hard to
picture how a cat hair could cause a problem but double sided tape not.
In any case there is no electronics in the bezel. There is nothing above
the top layer of plastic. There is a black layer two or three layers down,
perhaps that means something?
Luck;
Ken