|
Installed Calibre from Raspian repositories, (either apt-get install calibre, or use Aptitude or Synaptic if installed.) Version from repositories is 8.5. Works as far as I can tell in GUI. Problem is I have a Kindle Fire HD and it uses MTP protocol which was not supported until Calibre 9.x.
Downloaded current 9.x Calibre from website and followed directions. System still runs 8.5.
Set up a fresh Raspian CF card without install of Calibre 8.5. Then downloaded current Calibre 9.x as per the website. It is installed into /opt. Does not show up in the GUI menu system. Trying to run from command line says not found.
Any suggestions to getting it to run?
|