Thread: Need Help/Guide for debricking PW via Serial Port.
View Single Post
Old 04-03-2013, 11:20 AM   #5
twobob
( ͡° ͜ʖ ͡°){ʇlnɐɟ ƃǝs}Týr
twobob ought to be getting tired of karma fortunes by now.twobob ought to be getting tired of karma fortunes by now.twobob ought to be getting tired of karma fortunes by now.twobob ought to be getting tired of karma fortunes by now.twobob ought to be getting tired of karma fortunes by now.twobob ought to be getting tired of karma fortunes by now.twobob ought to be getting tired of karma fortunes by now.twobob ought to be getting tired of karma fortunes by now.twobob ought to be getting tired of karma fortunes by now.twobob ought to be getting tired of karma fortunes by now.twobob ought to be getting tired of karma fortunes by now.
 
twobob's Avatar
 
Posts: 6,586
Karma: 6299993
Join Date: Jun 2012
Location: uti gratia usura (Yao ying da ying; Mo ying da yieng)
Device: PW-WIFI|K5-3G+WIFI| K4|K3-3G|DXG|K2| Rooted Nook Touch
I will be trying out the TTL-232RG-VREG1V8-WE
Supports +1.8V TTL level UART signals and +1.8V / 100mA rated power output.

http://www.ftdichip.com/Products/Cab...BTTLSerial.htm

http://www.ftdichip.com/Support/Docu...2RG_CABLES.pdf

Once I have 100% confirmed the support / levels and correct wiring configuration I will write it up in full, with pictures, and links. Save future readers the pain of buying incorrectly specified products.

Cheers.

Quote:
The TTL-232RG-VREG1V8-WE

vreg == voltage regulated,
1V8 == 1.8 volts,
WE == wire ends

use Tx, Rx, Gnd only
cut others back out of way.
Last edited by twobob; 04-03-2013 at 01:09 PM.
twobob is offline   Reply With Quote