MobileRead Forums - View Single Post - Cannot sync sunrise xp to SD card on Tapwave Zodiac

clupea · 01-23-2006, 08:19 PM

I've been using Sunrise Desktop 0.42i to sync output to my first SD card on my Tapwave Zodiac2 without any problems (*thankyou*). I'm attempting to get XP alpha3 to sync to the card without luck.

The Hotsync Manager (v 5.2.6) throws the following error:

HotSync operation started 01/23/06 16:28:07
OK Date Book
[snip]
OK WordSmith
-- Cannot transfer document(s) to Secure Digital. No file system is present or the volume is read-only.
OK Sunrise XP with 1 message(s)
HotSync Error: Unknown error. (65)

The sxl file I'm using was converted from the sdl file I use w/0.42i. When I use the Hotsync Manager to View Files for Secure Digital (SD) Card for the Sunrise XP conduit I see the .pdb files in...

D:\Program Files\Tapwave\<user>\SunriseXP\vfs0

0.42i successfully writes to my Sandisk 512MB card under...

\PALM\Launcher

...so I know the card isn't write protected (the card in SD2 is - but that's not what's config'd for the output of the sxl file entries).

I created a test sxl file that transfers one of the feeds to RAM, and that does work with alpha 3. I'm stymied. What am I missing (probably something obvious - just not to me)?

Sandy

01-23-2006, 08:19 PM	#1
clupea harengus pallasii Posts: 7 Karma: 10 Join Date: Jan 2006 Location: Oregon Device: Palm T\|X, Tapwave Zodiac2	Cannot sync sunrise xp to SD card on Tapwave Zodiac I've been using Sunrise Desktop 0.42i to sync output to my first SD card on my Tapwave Zodiac2 without any problems (thankyou). I'm attempting to get XP alpha3 to sync to the card without luck. The Hotsync Manager (v 5.2.6) throws the following error: HotSync operation started 01/23/06 16:28:07 OK Date Book [snip] OK WordSmith -- Cannot transfer document(s) to Secure Digital. No file system is present or the volume is read-only. OK Sunrise XP with 1 message(s) HotSync Error: Unknown error. (65) The sxl file I'm using was converted from the sdl file I use w/0.42i. When I use the Hotsync Manager to View Files for Secure Digital (SD) Card for the Sunrise XP conduit I see the .pdb files in... D:\Program Files\Tapwave\<user>\SunriseXP\vfs0 0.42i successfully writes to my Sandisk 512MB card under... \PALM\Launcher ...so I know the card isn't write protected (the card in SD2 is - but that's not what's config'd for the output of the sxl file entries). I created a test sxl file that transfers one of the feeds to RAM, and that does work with alpha 3. I'm stymied. What am I missing (probably something obvious - just not to me)? Sandy Last edited by clupea; 01-25-2006 at 03:46 PM.